Handgunhunt

Harvest with 4 inch 686

Posted By: short30

Harvest with 4 inch 686 - 01/02/2020 7:15 PM

More by luck than skill but I finally checked off the goal of a deer harvest with the 4 inch SW 686. It wears a Weigand rail and a Matchdot II red dot. Aftermarket white polymer grips complement the stainless. I used a self-cast LBT WFN 185 grain water dropped bullet with gas check. Driven by 12.5 grains H110 so not a max load but still pretty stiff (As Max chuckles at this puny recoil).

30 Dec: I had a funeral visitation to attend and needed to be home and ready to leave at 5 pm so I grabbed the 686 and walked into a thick area just to see what might happen with the short time I had to hunt. While standing in the debris of a dead tree I had small doe walk by going in what would generally be the wrong direction. Later a second doe went by again in the ?wrong? direction. A few minutes later a group of 4 came by again headed up the mountain instead of down. Also apparently the rut has started in North Alabama because I had a small 4 point trail them then a few minutes later a spike wandered thru. I was about to sneak out when I just happened to spot a brown body and bino's revealed a main beam. Feeling very exposed and just knowing the swirling wind would betray me I stood as still as possible. The 8 point just stood for a long time and the spike was slowing moving to where I just knew he would smell me and blow out taking the 8 point with him. The bigger buck was a good 80 yards away in some thick cover. The spike walked within 15 yards but then turned and went back the way he came so I still had a chance. The 8 point slowly moved in my direction, worked a scrape but mostly used the licking branch, so cool to watch! The buck was at about 80 yards when I saw him and the area is ultra-thick even with no leaves so shot opportunities are few and with this pistol I had a 50ish yard limitation imposed by choice. I could see him but a shot was not possible. I lost sight of him while trying to keep track of the spike and I thought he might have followed the bench he was on around but he finally reappeared coming on the same path as the spike. I used the tree to brace but he moved thru two shooting lanes too fast for me to get a good sight picture. He finally stopped where I could only see his shoulder in the 6 inch gap between two trees at about 50 yards. I held mid shoulder and pulled the trigger. To my astonishment he simply dropped. I had spined him so I approached and shot again as he still moved his head and I was afraid he might get up. Autopsy seemed to reveal the spine shot hit mid spine from the side and did not exit. The second shot entered in the rear rib area, also grazed the spine then came to rest under the skin in the opposite front shoulder. Needless to say I was late but my very forgiving wife was patient while I dragged the deer out and my awesome son hung and gutted while we went to the visitation.

Pictures in the bragging board show the spine area and the hole in the rib is in line with the first shot but I think it and the recovered bullet is from the follow up shot. Bullet is pictured and I think it shows the slight smear from grazing the spine much further back. The follow up shot went thru about 18-20 inches of compressed deer since he was laying on his side. One picture shows the lump where the bullet was recovered. I did not find the first bullet but I think it is buried in the spine. Processor said he would look for it. This deer must have been a fighter although maybe not a very good one. His face is scared up and his ear was broken and healed folded as you see in the picture.
Pictures are in the bragging board. Now I have to get the .45 SBHH into action and maybe initiated before the season runs out.

Posted By: sixshot

Re: Harvest with 4 inch 686 - 01/02/2020 7:21 PM

Good for you, proves once again that shot placement is key. Especially if the caliber is a bit towards the small side. You made a great shot & got your venison. Congratulations!!

Dick
Posted By: Russell

Re: Harvest with 4 inch 686 - 01/02/2020 8:06 PM

Congratulations on staying focused and picking your shot!
Posted By: Mark Hampton

Re: Harvest with 4 inch 686 - 01/02/2020 11:49 PM

Nice job - Congrats!
Posted By: PsTaN

Re: Harvest with 4 inch 686 - 01/03/2020 12:21 AM

Very nice write-up. I've heard there are a few bucks chasing here in South Alabama, but I'm not finding scrapes yet along my known lines used annually.

Grats!
Posted By: junebug

Re: Harvest with 4 inch 686 - 01/03/2020 12:31 AM

Well done!
Posted By: kalhoon

Re: Harvest with 4 inch 686 - 01/03/2020 12:55 AM

Skeeter would be proud.Congrats on a great deer.
Posted By: RBO21

Re: Harvest with 4 inch 686 - 01/03/2020 2:02 AM

Congrats! Now I want to go shoot one with my 686!
Posted By: cherokeetracker

Re: Harvest with 4 inch 686 - 01/03/2020 3:18 AM

Well done
Posted By: Okie Hunter

Re: Harvest with 4 inch 686 - 01/03/2020 8:28 AM

Congrats.
Posted By: jcp161

Re: Harvest with 4 inch 686 - 01/03/2020 1:30 PM

Congratulations!

Nice buck and a great story.
Posted By: Shortgun

Re: Harvest with 4 inch 686 - 01/03/2020 1:39 PM

Congrats!!! I would like to do the same thing with my 6? GP100. Hope to accomplish that next year.🦌
Posted By: short30

Re: Harvest with 4 inch 686 - 01/03/2020 3:40 PM

PsTaN - I have seen little to no rutting activity here but I am very short on bucks so this guy just wandered thru at the wrong time. There are no rubs or scrapes that I have found but I do want to go back and find the licking branch this guy was using and see how much use is there or if he was just starting a scrape.

Shortgun: I committed to the 686. I was also carrying a scoped contender but knew I would opt for it in such an event so I stopped carrying it. I am considering a 6 inch or 8 inch upgrade in the future.

Thanks all, I feel very fortunate.
Posted By: KRal

Re: Harvest with 4 inch 686 - 01/03/2020 6:59 PM

Well done, congrats!
Posted By: Ernie

Re: Harvest with 4 inch 686 - 01/04/2020 8:14 PM

Good for you!
Posted By: jamesfromjersey

Re: Harvest with 4 inch 686 - 01/05/2020 2:01 AM


Nothing I enjoy more then seeing a handgunner cleanly take game with a cartridge (from a four inch barrel no less) that is ill-advised by others.... I love to ask your whitetail if he found your handload "light"..
\:\(
Posted By: ruger4570

Re: Harvest with 4 inch 686 - 01/05/2020 1:56 PM

Congrats. Nice job and writeup.
Posted By: racksmasher1

Re: Harvest with 4 inch 686 - 01/05/2020 10:15 PM

Congrats on a nice buck
Posted By: dave thomas

Re: Harvest with 4 inch 686 - 01/08/2020 2:24 PM

nicely done!
© 2024 Handgunhunt forums