Torque Specs?

I have recently acquired a Ruger Toklat in 454/45 Colt.

Today I spoke to Ruger and have 30mm rings on the way and just placed an order for an Ultradot 30.

Are there recommended or suggested torque values for the base screws and ring screws for the Ruger rings? If not, what have you guys found that works for this set-up?

Thanks for your help!

I don't know what Ruger recommends. If you call them, they'll tell you. But, I run 45 inch pounds on the big cross bolt screws and 25 inch pounds in the small ring screws.

Perfect!

The scope arrived today, hopefully the rings are not too far behind.

Thankd for your help